Baliza de alta intensidad BA2000 Tipo A

Famille : Balizaje aéreo
Catégorie : Balizas de alta intensidad

Technical Advantages

• Flashhead and control panel can be separated by up to 600 m

• BA 2000 does not need a separated and costly control panel to synchronize the flashes.

Only requires an interconnecting cable of 18 AWG (no high amps)


Control Panel

The control panel of our high intensity strobe light is designed from the latest technology. The power controller contains the circuits that provide the energy to the flash head, control, and monitor the system functions. Importantly, all of the electronics are located at ground level. The power controller can be separated by up to 600 meters from the flash head. Therefore, the repair technician does not have to climb the tower and most of the maintenance can be done at ground level.

The panel used only 2 electronic boards  :

• Control board

• The high voltage and trigger board

Our high intensity strobe light system do not need an additional expensive control panel for:

• flash synchronization

• setting the photocell mode

• setting the timing of catenary’s wires flashes

• monitoring the status of the system

• generating alarms

A state-of-the-art microprocessor controls the entire electronic system and makes the solid-state circuit configuration smaller and smarter. For example, a “watch dog” continuously checks the microprocessor and prevents the system from freezing.


The only installation settings to change would be to set a dipswitch in the case you have to mark the catenary’s wires. For daytime and nighttime, the flash rate is factory calibrated to the ICAO specification and will never require resetting. Simply changing the position of the switch on the control board can test the day and the night modes. See section II.4 Test day and night modes.

The control panel is protected from lightning with the use of fibreglass flash head enclosure and with a metal oxide varistor (M.O.V.) in the electronic circuit.